FOGCOntroller II Microprocessor Humidity Only 1 Zone
The FOGCOntroller II is a humidity controller with an internal humidity sensor that provides automated operation of a fog system. The unit can operate based on its internal sensor or it can be wired to an external sensor if the controller needs to be in a different location than the sensor.
The FOGCOntroller II is a single zone microprocessor and has two output relays with a programmable delay start and stop. The sensors are fully calibrated re-flow humidity sensors with digital output that sends binary data over RS485 protocol. The internal and the standard external sensor will have an accuracy of +/- 2% from 10% to 70% humidity. The high humidity sensor will have an accuracy of +/- 2% from 0 to 99% humidity.
The internal sensor or the standard external sensor is recommended for applications requiring from 10% to 70% humidity. For humidity levels above 70%, the Fogco high humidity sensor should be used to avoid condensation build up on the sensor chip.
The controller requires a 50 watt 24 VAC transformer as a power supply.
Showing all 8 results
#94160$509.00Add to cart
#92906$785.00Add to cart
Fogco Remote High Humidity Sensor
#92909$315.00Add to cart
Fogco Remote Temperature/Humidity Sensor
#92908$23.00Add to cart
4 Pin Connector
#92907$1.02Add to cart
4 Wire Shielded Instrumentation Cable Per Foot
#94207$1.06Add to cart
18 AWG 150V 2 Conductor Cable Per Foot
#92930$1.49Add to cart
18 AWG 300V 3 Conductor Cable Per Foot
#94208$1.99Add to cart
18 AWG 150V 4 Conductor Cable Per Foot